Milling Cutter suits roughing and finishing of cast iron.October 25, 2010 -
Through use of tangentially mounted inserts accompanied by adjustable axially mounted wiper inserts, SumiMill GOALMILL Milling Cutter provides optimal surface finishes. Each insert offers 8 indexes when using single-handled cutters. Four indexes can be used on periphery pockets, and flipping insert on its side allows for 4 more indexes in finishing cartridge. GOALMILL Cutter is available for roughing to less than 50 Rz, semi-finishing to less than 18 Rz, and finishing to less than 12.5 Rz.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Sumitomo Electric Carbide
1001 Business Center Dr.
Mount Prospect, IL, 60056
USA
Sumitomo Unveils Sumimill Goalmill Milling Cutter for Roughing and Finishing Cast Iron
Mount Prospect, IL - New from Sumitomo Electric Carbide, Inc., the SumiMill GOALMILL Milling Cutter finishes cast iron with exceptional accuracy.
The GOALMILL provides excellent surface finishes through the use of tangentially mounted inserts accompanied by easily adjustable axially mounted wiper inserts. Each insert offers eight indexes when using single-handed cutters. Four indexes can be used on the periphery pockets, and flipping the insert on its side allows for four more indexes in the finishing cartridge. A total of 12 indexes can be used when employing both right and left hand cutters.
GOALMILL cutters are available for roughing (<50Rz) semi-finishing (<18Rz) and finishing (<12.5Rz). Left-handed cutters are made to order.
For more information, contact Sumitomo Electric Carbide, Inc., 1001 Business Center Drive, Mount Prospect, IL 60056, Phone: (800) 950-5202, Fax: (847) 635-9335, e-mail: info@sumicarbide.com, or visit www.sumicarbide.com.
|
|
|
|
|
|
|
| 
