Mid-Feed Cutters feature inscribed circle inserts.
February 29, 2012 -
Part of RHINO-FEED(TM) line, Mid-Feed Cutters are optimized for cuts of 1-3 in. diameter and max depth of .045 in., with 10 mm inscribed circle inserts featuring 4 usable edges. End mills, shell mills, and modular heads are available with 2, 3, 5, or 6 flutes. Mid-Feed cutters are suited for light-duty machines running at moderate FPT. RHINO-FEED line adjusts feed rates to compensate for chip thinning that occurs during high-feed milling when extreme lead angle is utilized.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Dapra Corporation
66 Granby St.
Bloomfield, CT, 06002
USA
New RHINO-FEED(TM) Mid-Feed Cutters and Inserts Provide High Feed Milling Rates up to 5 Times Faster Than Normal
Dapra Corporation's new Mid-Feed cutters and inserts - part of its high-feed RHINO-FEED(TM) line - provide an excellent high-feed milling solution, allowing for extreme feed rates in light- to moderate-DOC applications.
Dapra's Mid-Feed line is optimized for cuts of 1.000" to 3.000" diameter and a maximum depth of .045", with 10mm IC (inscribed circle) inserts featuring four usable edges. End mills, shell mills and modular heads are available with two, three, five or six flutes. Mid-Feed is well suited for lighter-duty machines (40-taper, linear ways, etc.) running at moderate FPT.
Dapra's RHINO-FEED line adjusts feed rates to compensate for the significant chip thinning that occurs during high-feed milling when an extreme lead angle is utilized. Mini-Feed and Heavy-Feed cutters and inserts are also available for diameters from .500" to 4" and depths of cut from .015" to .060". Visit www.dapra.com for more information about this new line and to view product demo videos. Contact Dapra toll-free at (800) 243-3344 or info@dapra.com.
|
|
|
|
|
|
|
|
