Laminating System processes delicate materials.
September 12, 2002 - Sheet-Fed Laminating/Die-Cutting system feeds sheets of foam through water-heated laminating station, laminates 2 layers of adhesive to top of material, and laminates substrate to bottom. It feeds sheets to optically registered die-cutter, which cuts out final product. Product is removed from matrix by knockout station onto side-exiting conveyor. Matrix is sheeter cut to conveyor for waste disposal. System uses PID loop to control tension.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Contech
1760 S. 151st St. W.
Goddard, KS, 67052
USA
New Contech Sheet-Fed Laminating/Die-Cutting System
With a design focusing on material tension, the new CONTECH Sheet-Fed Laminating/Die-Cutting System processes delicate materials easily and efficiently.
Using a PID loop to precisely control tension by ounces per linear inch, sheets of foam are fed by an automatic sheet feeder module through a water-heated laminating station. Two layers of adhesive are laminated to the top of the material while a substrate is laminated to the bottom. The sheets are then fed to an optically registered die-cutter, cutting out the final product at extremely close tolerance. The product is removed from the matrix by a knockout station onto a side-exiting conveyor - the matrix is sheeter-cut to conveyor for waste disposal.
CONTECH's custom Automation Engineering capability allows them to design, engineer, and build laminating and die-cutting systems to customer's exact specifications, making them completely compatible with existing plant equipment. CONTECH manufactures a complete line of material processing equipment including sheeters, slitters, rewinders, applicators and more.
CONTECH, 1756 S. 151st St. West, Goddard, KS 67052, (800) 961-6449 Fax: (316) 722-2976, www.contech-usa.com
|
|
|
|
|
|
|
| 
