Knife Making Furnaces offers varying degrees of digital control.
September 12, 2011 -
Xpress-KM series comes equipped with Sentry Xpress 3-key digital controller, while KM-series comes with Sentry 12-key controller. Sentry Xpress can store 4 programs in memory, each with up to 8 segments. Standard temperature rating on both versions is 2,350°F, allowing knife makers to heat treat variety of steels. Door on furnaces open downward, counter-balance handle keeps door closed, and safety door switch turns off elements when door is opened.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
|Original Press release |
Paragon Industries, L.P.
2011 S. Town E. Blvd.
Mesquite, TX, 75149
Paragon Introduces New Xpress-KM Series Knife Making Furnaces
MESQUITE, TX - Paragon Industries has just introduced the Xpress-KM series knife making furnaces, which are made in Mesquite, Texas. The new Xpress-KM furnaces are equipped with the Sentry Xpress 3-key digital controller. Paragon's current KM-series, which they began manufacturing in 1986, come with the Sentry 12-key controller.
The standard temperature rating on the KM and Xpress-KM knife making furnaces is now 2350 degrees F. "We raised the temperature rating so knife makers could heat treat the newest steels," said Arnold Howard, spokesman for Paragon.
"The only difference between the Xpress-KM and KM furnaces is the digital temperature controller," said Howard. "The 12-key Sentry has more features than the economically priced 3-key Sentry Xpress." The Sentry Xpress can store four programs in memory, each with up to eight segments.
The door on Paragon knife making furnaces opens downward. A counter-balance handle keeps the door closed. A safety door switch turns off the elements when the door is opened.
For more information, contact Paragon: 800-876-4328 / 972-288-7557 / www.paragonweb.com / firstname.lastname@example.org / 2011 South Town East Blvd., Mesquite, TX 75149-1122