IP67 Wall-Mount Enclosures survive harsh environments.December 1, 2010 -
Designed for wall mounting PCB- or DIN rail-based equipment used in harsh environments or outdoor applications, 1555F series comes in RAL 7035 light gray and molded general-purpose ABS or flameproof polycarbonate. Lid is secured to wall or other surface, while in use, via slots moulded into integral flanges. Offered in 6 sizes from 4.7 x 2.60 x 1.65 in. to 6.30 x 3.60 x 2.44 in., enclosures achieve environmental sealing via tongue and groove design and molded silicon rubber gasket.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Hammond Manufacturing Co., Inc.
4700 Genesee St.
Cheektowaga, NY, 14225
USA
IP67 Wall Mounted Enclosures for Harsh Environments
The new 1555F range from Hammond Manufacturing is a family of rugged IP67 sealed enclosures designed for wall mounting PCB-based or DIN rail based equipment such as security components, control equipment and radio repeaters used in harsh industrial environments or outdoor applications. Available in RAL 7035 light gray and moulded in either general purpose ABS or flameproof polycarbonate, the units have a number of innovative features that provide excellent functionality. In use, the lid is secured to the wall or other surface using the slots moulded into the integral flanges. The screws securing the lid to the base are then inaccessible as they are against the surface, giving security against unauthorised tampering. For maximum security, the units can be attached to the wall with tamper-resistant screws. Standoffs are moulded into both the lid and the base and, apart from in the two smallest sizes, DIN rail mounting tabs are also provided. The bottom of the base features a moulded recess for a membrane keyboard or label.
The initial six sizes range from 4.7" x 2.60 x 1.65" (120 x 66 x 42mm) to 6.30 x 3.60 x2.44" (159 x 91 x 62mm); all lids are fitted with captive M4 stainless steel screws that engage with stainless steel inserts in the base, allowing repetitive assembly and disassembly. Environmental sealing is achieved through a tongue and groove design and a moulded silicon rubber gasket; all fixings are outside the gasket seal.
For further information contact:
Ray Shatzel
Hammond Manufacturing Co. Inc.
475 Cayuga Rd. #100
Cheektowaga
NY 14225-1309
Tel: (716) 630-7030
Fax: (716) 630-7042
rshatzel@hammfg.com
www.hammondmfg.com
Hammond is one of the world's leading manufacturers of small plastic, die-cast and metal enclosures for use in the electronics, electrical and allied industries.
|
|
|
|
|
|
|
| 
