Guard Rail System offers bolt-together installation.
December 15, 2003 -
Available in 1 ft increments in lengths from 2-10 ft, Handle-It(TM) protects areas such as office walls, mezzanines, water mains, electrical boxes, and personnel walkways. Manufactured with 10 gauge steel square tube mounted on 10 in.² base plates, columns are available as single (18 in. high) or double (42 in. high). To achieve maximum protection from forklift damage, system withstands 10,000 lb at 4 mph with 12 in. deflection or less.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
MII Equipment, Inc.
P.O. Box 26335
Milwaukee, WI, 53226
USA
Material Handling Equipment
Handle-It(TM) is proud to announce the introduction of its new Guard Rail system. Guard Rail is used for protection of such areas as office walls, mezzanines, water mains, electrical boxes, and personnel walkways. Considering the high cost of replacing and repairing these items, the price of the Handle-It(TM) Guard Rail can't be beat.
With Handle-It(TM)'s innovative design, the flange nuts are welded inside the columns. Handle-It Guard Rail is the easiest to install. Installation consists of simply anchoring the support columns to the floor and bolting the rails to the columns with the supplied hardware. This system allows for complicated configurations to be set up in a fraction of the time it takes most systems.
Handle-It(TM) Guard Rail is available in one-foot increments starting at a length of two feet all the way up to ten feet. To achieve maximum protection from forklift damage, Handle-It(TM) Guard Rail is designed and tested to withstand 10,000 pounds at four miles per hour with 12" deflection or less.
Also available from Handle-It(TM) is a Lift-Out Adapter. The Lift-Out Adapter is used when it is necessary to access equipment or space behind the Guard Rail. The adapter is a slot assembly bolted to the columns that allows Guard Rail to slide in and out of the column.
Columns for the rail are available in both single (18" high) and double (42" high). These columns are manufactured with 10 gauge steel square tube mounted on 10" by 10" base plates for maximum strength and durability.
For information on the new Handle-It(TM) Guard Rail System, call MII Equipment, Inc. at 1-800-236-1080, fax us at 414-453-9975, or visit our web site at www.miiequipment.com.
|
|
|
|
|
|
|
|
|
|
| 
