Flow Computers are designed specifically for irrigation.
September 9, 2011 -
Series NFC100 flow computers range from versions with battery power and no outputs to those with universal inputs for DC and AC power and multiple outputs, including relay outputs with programmable alarm delay and remote alarm reset input. All offer stable and reliable flow rate reading and outputs, with pulses down to one pulse every 5 min, and also control outputs at same time. Accurate measuring and dosing can be achieved using GMAG100 totalizing magmeter.
Original Press release
G Instruments
13240 Evening Creek Dr
San Diego, CA, 92128
USA
New Line of Devices for Irrigation
San Diego, CA - G Instruments, an R&D and manufacturing company of instrumentation and controls, released a new line of flow computers for irrigation. They have a stable and reliable flow rate reading and outputs with pulses down to one pulse every five minutes.
Most flow meters for irrigation like registers, opto-couplers and others produce very low frequency pulses, sometimes one pulse in a few minutes. Typical flow computers are not able to display stable and accurate flow rate and control their outputs accordingly. Most of them can not even measure and display the flow rate at all.
G Instruments new line of flow computers is a special design for irrigation. All of them measure accurately and display flow rate with input pulses down to one pulse every 5 minutes. They also control their outputs accurately and reliably in the same time.
Ranging from battery power with no outputs to universal inputs for DC and AC power and multiple outputs, including relay outputs with programmable alarm delay and remote alarm reset input, NFC100 series flow computers from G Instruments are the perfect solution for irrigation.
Accurate measuring and dosing of fertilizer, biocides and other liquids can be achieved using GMAG100 totalizing magmeter with built-in RS485 MODBUS RTU. The magmeter can accurately measure interrupted and highly pulsating flow in an extremely large turn-down ratio.
http://www.ginstruments.com/irrigation.htm
G Instruments, located in San Diego, California, is a small R&D and manufacturing company for magmeters, flow meters, flow computers / totalizers, SCADA, temperature transmitters, conductivity transmitters and many others. The number of products will continue to grow fast ....
www.Ginstruments.com
sales@Ginstruments.com
Phone: 858-231-5156
Fax: 858-876-1963
|
|
|
|
|
|
|
| 
