Floor-/Wall-Mounted Jibs feature 50 lb capacity.November 20, 2008 -
Two 9 ft high, floor-mounted supports (F50 series) and two wall mounted supports (W50 series) are available with 6 or 4 ft long rotating jib, which is height-adjustable in 6 in. increments and supplied with 4-wheel trolley to suspend tool balancer. Each 6 ft jib includes festooning trolley to support air lines or electric cables. Additionally, each 9 ft high vertical post is fabricated with 7 ga steel and supplied in 2 sections.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Nasco Industries Inc.
3541 N.W. 53 St.
Fort Lauderdale, FL, 33309
USA
Floor & Wall Mounted Jibs with 50 lbs. Capacity - F50 & W50 Series
Nasco Industries extends its line of tool supports with the introduction of the 50 lb. capacity support systems available in four models. These consist of two floor mounted supports, both 9' high, and two wall mounted supports. Both mounting configurations are available with either a 6' long or 4' long rotating jib. Each jib is supplied with a four wheel trolley to suspend a tool balancer. Each 6' jib includes a festooning trolley to support air lines or electric cables.
Each 9' high vertical post is fabricated with 7 ga. steel and is supplied in two sections so that the entire system is shippable via UPS. The rotating jib is height adjustable in 6" increments using mounting holes provided on the vertical post. The new jib support systems are an addition to Nasco's extensive line of 10 lb. capacity B1 & B2 bench mounted tool supports and 30 lb. capacity BH, FH & WH bench, floor and wall mounted tool supports.
|
|
|
|
|
|
|
| 
