End Wire Brush suits heavy-duty fabrication applications.
February 10, 2009 -
Controlled Flare End Brush (CFE) is designed to remove heavy weld spatter, flash, and scale in hard-to-reach areas such as right angles and corners. Patent-pending design reduces filament fatigue resulting in less wire breakage in heavy-duty fabrication applications. Product is available in both steel and stainless steel wire with .0104, .014, and .020 dia, while brush diameters include ½, ¾, and 1 in. in various trim lengths.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Anderson Products
1040 Southbridge St.
Worcester, MA, 01610
USA
New Controlled Flare End Brush from Anderson Products
Anderson's new Controlled Flare End Brush (CFE) is specially designed to remove heavy weld spatter, flash and scale in hard-to-reach areas such as right angles and corners. Unlike conventional end brushes, the patent-pending design of the new CFE reduces filament fatigue resulting in less wire breakage in demanding applications; increases durability when cleaning right angles, fillet welds and corners; and allows only minimal flaring, so more wire points can aggressively clean the surface.
These brushes are ideal for heavy-duty fabrication applications such as weld cleaning, deflashing, roughening, rust and oxidation removal and surface preparation.
Anderson CFE's are available in both steel and stainless steel wire with diameters of .0104, .014 and .020. Brush diameters include ½", ¾" and 1" in various trim lengths.
For additional information, please contact Anderson Products at (800) 755-6101,
FAX: (800) 729-4694, www.andersonproducts.com
|
|
|
|
|
|
|
| 
