Dual Input pH/ORP Controllers are UL, CSA, and CE compliant.
February 23, 2009 -
Accepting 2 electrode signals in any combination of pH and ORP, WDP400 Series dual input pH/ORP controllers suit industrial, commercial, and municipal water treatment applications. There are 4 control outputs, available as on/off control relays, or as pulse proportional outputs to directly drive electronic metering pumps. Each control output can be assigned to either electrode, and relays can be either high or low set point, high or low alarm, in range alarm, out of range alarm, or probe wash.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Walchem Corp.
5 Boynton Rd., Hopping Brook Park
Holliston, MA, 01746 1460
USA
WDP400 Series Dual Input pH/ORP Controllers
January, 2009 - Holliston, MA
Walchem is pleased to announce the introduction of the WDP400 Series Dual Input pH/ORP controllers. These versatile controllers are designed for a broad range of industrial, commercial, and municipal water treatment applications. WDP controllers accept two electrode signals, in any combination of pH and ORP, and are offered in a convenient pre-wired NEMA 4X wall mount package that can be installed in minutes. The dual input model reduces space requirements and is more cost effective than two single input models. Integrated data logging is available to validate system performance. A USB stick is all that's needed to extract data and event logs that include electrode measurements, temperature, accumulated chemical feed and relay activation times.
There are four control outputs, available as on/off control relays, or as pulse proportional outputs to directly drive electronic metering pumps. Each control output can be assigned to either electrode, and relays can be either a high or low set point, high or low alarm, in range alarm, out of range alarm or probe wash.
One or two optional isolated 4-20mA outputs are available, which can be assigned to either electrode input, to correspond to the pH, ORP or temperature.
All controllers are compatible with the WEL Series pH/ORP electrodes, which offer an extremely reliable differential measurement technique that is immune to any possible ground loop problems.
Electrode troubleshooting is simplified through self-diagnostics.
All models meet UL, CSA and CE standards for safety and performance, providing reliable operation in harsh industrial environments subject to electrical or radio frequency noise interference.
For more information, please contact:
Walchem
5 Boynton Road
Holliston, MA 01746
Tel: 508-429-1110
email: info@walchem.com
web: www.walchem.com
|
|
|
|
|
|
|
| 
