Digital Load Cell Display supports TEDS-enabled sensors.
March 6, 2007 -
Scaleable to 5 digits, IPM500 Panel Mount Signal Conditioner with Digital Display supports sensors with TEDS ID recognition option per IEEE1451.4. TEDS option features auto-configuration, which minimizes error due to setup and re-installation. In addition to providing stable and regulated excitation voltage to sensor, unit also provides 0-10 Vdc and 4-20 mA analog output as well as RS232/RS485 and USB interface to be used with PLC, DAQ card, or computer.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Futek
10 Thomas
Irvine, CA, 92618 USA

Digital Load Cell Display with "TEDS"
FUTEK's popular IPM500 Panel Mount Signal Conditioner w/ Digital Display will now support sensors with "TEDS" ID recognition option per IEEE1451.4. "TEDS" (Transducer Electronic Data Sheet) option features an auto-configuration which minimizes error due to setup and re-installation. This product is widely used by system integrators and test engineers in laboratory, medical, automotive and aerospace instrumentations. In addition to providing a stable and well regulated excitation voltage to the sensor, it also provides 0-10 VDC & 4-20 mA analog output as well as RS232 / RS485 and USB interface to be used with PLC, data acquisition card or computer. FUTEK's IPM500 display is the ideal solution for a complete sensor and instrumentation system. Some of the key features for this digital load cell display include:
· Scaleable to 5 digits. ±99,999
· 60 conversions per second
· Peak & valley hold and remote auto tare
· Bidirectional Scale factor.
· 6 wire connection supporting sense lead
· Analog output for PLC controls
· Dual setpoint alarm with built-in relays
· USB & RS232 / RS485 computer interface
· Software (Data Display & recording TEDS read & write)
Please visit www.futek.com for more information on this digital display, or its comparable bench top version, the IBT500.
|
|