Depaneling System eliminates bending loads and edge stresses.
January 23, 2003 - DATUM incorporates circular saw and router technology into one automation platform, simultaneously addressing board spacing problems and meeting panel layout demands. With modular design, it offers 18 x 18 in. routing window, video-aided programming, and broken bit/blade detection. Rout speeds reach up to 3 in./sec, and saw speeds reach up to 8 in./sec. Servo repeatability is ±0.0005 in., and servo-driven z-axis saw blade rotates 270° to perform angular cuts.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Cencorp
5405 Spine Rd.
Boulder, CO, 80301
USA
The Revolutionary New DATUM Depaneling System
LONGMONT, CO - Cencorp, a subsidiary of PMJ Automec Oyj, announces the revolutionary new DATUM depaneling system, incorporating both circular saw and router technology into a single automation platform. It is the first machine to simultaneously address board spacing problems while meeting the demands of standard panel layouts.
DATUM addresses the increasing demands of densely populated, multi-layered boards with traces near the edge of the score line. The system eliminates bending loads and edge stresses associated with standard manual/semi-automatic systems, while exceeding traditional depaneling throughput rates.
Additional benefits to electronics assemblers:
• Dramatic price/performance enhancement over single-technology systems
• Low cost tooling
• Fast and easy product changeover
• Modular design, small footprint
• Large routing window: 18"x18" (457mm x 457mm)
• Video-aided programming for fast and accurate programming
• Broken bit and/or blade detection
Fast and accurate, DATUM offers rout speeds of up to 3" (5 mm) per second or saw speeds up to 8" (200 mm) per second. Servo repeatability is +/- 0.0005" (0.127mm). A unique servo-driven z-axis saw blade accommodates varying component heights, and can rotate 270 degrees to perform angular cuts.
About Cencorp
Cencorp, LLC designs and manufactures high-quality post-assembly routing systems, with more than 25 years of experience in leading-edge automated applications for the surface mount and high density interconnect industries. Cencorp offers a complete line of flexible, accurate, and gentle stand-alone and in-line depaneling systems, including the TR1000, TR2100/2101/2400, SR1200, TR5000, and DATUM Series.
Headquarters is located in Longmont, Colorado, USA, with sales and service affiliates located throughout the Americas and Europe. Cencorp is a subsidiary of PMJ Automec Oyj.
www.cencorp.com
Cencorp is located at 410 South Sunset Street, Suite A, Longmont, CO 80501
Tel: (303) 702-0081; Fax: (303) 702-1270; Web: www.cencorp.com
|
|
|
|
|
|
|
| 
