DSP-Enabled Test Kit determines soluble salt levels.
December 30, 2009 -
Optimized for speed and accuracy by leveraging Direct Sampling Procedure (DSP), Bresle Chloride Test Kit includes all necessary equipment for assessing level of soluble salts on blast-cleaned surfaces prior to coating. It complies with ISO 8502-6 and ISO 8502-9 standards and is also suitable for determining contamination of blast-media in use as to prevent dissolved salts in recycled abrasive media or water from re-contaminating surface being cleaned.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Paul N. Gardner Co., Inc.
316 N.E. 1st St., Dept. TR
Pompano Beach, FL, 33060 6608
USA
DSP Bresle Chloride Test Kit
Features unique Direct Sampling Procedure (DSP) to ensure high speed and accuracy. Up to 60 times more accurate than other test kits available. Also uses a smaller test sample for measurement.
The Bresle Chloride Test Kit includes all the necessary equipment for assessing the level of soluble salts on blast-cleaned surfaces prior to coating. Inside the Bresle Kit is a conductivity gage used for the assessment of soluble salt ions as chlorides, sulphates and nitrates. The Bresle Kit complies with the ISO 8502-6 and ISO 8502-9 standards, describing the Bresle Method, which states that the conductivity is mainly directly proportional to the concentration of dissolved salts in the solution. ISO 17025 approved certificate of patches available on request.
Contamination of blast-media
The Bresle Kit is also suitable to determine the contamination of blast-media in use. This is to prevent the dissolved salts in the recycled abrasive media or water from re-contaminating the surface being cleaned. The blasting media can be tested following ISO 11127-6.
|
|
|
|
|
|
|
| 
