Current to Analog Converters measure less than one inch wide.
August 15, 2011 -
Available from 0-1 A to 0-10 A, Current to Analog Converters allow user to monitor flow of current in circuit indicating circuit is operating and load is connected and active. Use of Hall Effect sensor enables both AC and DC currents to be measured. Since 3 different common analog outputs are available, modules will work in any control application where current to analog signal conversion is required.
Original Press release
Automation Systems Interconnect Inc.
4700 Westport Drive, Suite 500
Mechanicsburg, PA, 17055
USA
New Compact Current to Analog Converters
Mechanicsburg, PA - Automation Systems Interconnect Inc. (ASI) is pleased to announce the introduction of a complete new line of compact current to analog converters. Only 6.2mm (.99") wide and available 0 to 1 amps up to 0 to 10 amps. Since 3 different common analog outputs are available these modules will work in just about any control application where current to analog signal conversion is required.
Current to Analog converters allow the user to monitor the flow of current in a circuit indicating the circuit is operating and the load is connected and active. Through the use of a Hall Effect sensor both AC and DC currents can be measured.
Specifications and prices along with product details can be found on ASI's website. All of the ASI new signal conditioners can be ordered Direct Online with a saving of 20 - 50% by going to www.asi-ez.com. For additional information please contact ASI at P.O. Box 1340, Mechanicsburg, PA 17055, by calling 1-877-650-5160, or by visiting their website at www.asi-ez.com.
|
|
|
|
|
|
|
| 
