Close-Coupled Mag-Drive Pump eliminates corrosion.
August 23, 2010 -
Available in sizes from 1.5 x 1 x 6 in. to 3 x 2 x 8 in., CHEM-GARD® CGMC offers flows to 400 gpm at heads to 220 ft TDH. Unit features sealless, single-stage, volute-type centrifugal design with all fluid contact components molded of homogenous polypropylene or PVDF. Chemically inert, abrasion-resistant thermoplastic components eliminate pinpoint porosity, substrate separation, and wear. Available with ANSI centerline suction and discharge, pump accommodates C-face motors.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Vanton Pump & Equipment Corp.
201 Sweetland Ave.
Hillside, NJ, 07205
USA
Thermoplastic Close-Coupled Mag-Drive Pump
REDUCES FOOTPRINT, ELIMINATES CORROSION, CONTAMINATION
HILLSIDE, NJ, USA - A new CHEM-GARD® CGMC close-coupled, magnetically-driven thermoplastic centrifugal pump in sizes from 1.5x1x6 to 3x2x8 in. (38x25x152 to 76x51x203 mm) for flows to 400 GPM (91m3/hr) at heads to 220 ft TDH (50m), has been introduced by Vanton Pump, it was announced by Ken Comerford, VP of Sales and Marketing.
The pump is a sealless, single-stage, volute-type centrifugal design with all fluid contact components molded of homogenous polypropylene or PVDF. These stand alone, chemically inert, abrasion-resistant thermoplastic components eliminate pinpoint porosity, substrate separation and wear associated with plastic lined pumps.
An addition to the company's CHEM-GARD line of conventionally coupled CGM magnetically driven pumps, the close-coupled CGMC design reduces overall length by approximately 20 percent, allowing placement in restricted spaces typically encountered in replacement and OEM applications.
Permanent rare earth magnets transmit power, with the inner magnet rotor assembly encapsulated in thick-walled thermoplastic. A non-metallic containment can assembly reduces losses in magnetic force and pump efficiency by eliminating troublesome eddy currents.
Available with ANSI centerline suction and discharge, the pump allows removal for maintenance without disturbing existing piping, and can accommodate standard C-face motors. The thermoplastic wet end is encased by structural metal armor that is protected by a chemical resistant epoxy coating, enabling the pump to withstand hostile environments and tolerate the same nozzle loadings as metal pumps.
Vanton Pump offers a range of other horizontal centrifugal thermoplastics pumps, as well as vertical centrifugal thermoplastic sump pumps, sealless peristaltic pumps, and integrated non-metallic tank/pump systems.For information contact Vanton Pump & Equipment Corp., +1-908-688-4216, mkt@vanton.com, www.vanton.com
|
|
|
|
|
|
|
| 
