Clamped Duct carries mists, fumes, dust, and trim scrap.
February 14, 2007 -
Designed to hasten installation and facilitate system modification, Clamp-Together Duct is available in 24-10 gauge thick galvanized or stainless steel in 1 in. dia increments from 3-24 in. It is assembled with lifetime-guaranteed Forever Clamp and suited for any negative-pressure ventilation system up to 40 in. wg with entrained dust, sand, fumes, mist, smoke, chips, or trim scrap. Adjustable sleeves and components enable field fitting to any length.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
K&B Duct
8735 W. Market St.
Greensboro, NC, 27409
USA
New Clamp-Together Duct for Mists, Fumes, Dust, Trim Scrap and Dusts
Lifetime-guaranteed Forever Clamp and infinitely adjustable length allow easy installation and system modifications. Wide range of materials, gauges, sizes and accessories cover applications from food to coal dust.
February 2007 - Kirk & Blum's expanded line of clamp-together duct is designed for quick installation and easy system modification, and now supported with free 3-D design software to ensure system performance and easy installation. Assembled with the lifetime-guaranteed Forever Clamp, the duct is available in galvanized or stainless steel in one-inch diameter increments from 3" to 24" with accessories such as in-line mist accumulators, industrial-grade blast gates, swiveling ball joints, sweeps, hoods and all other components required for total system. Clamp-together duct is ideal for virtually any negative-pressure ventilation system up to 40" water gauge with entrained dust, sand, fumes, mist, smoke, chips, trim scrap, etc. Higher pressures can be accommodated on request.
Clamp-Together duct ranges from 24 gauge to optional 10 gauge thickness in galvanized and stainless steel with numerous options, including FDA-approved gaskets and seam seals for food applications or ground-and-buffed interior welds and seams for stranded or stringy materials. The rolled lip on the duct and fittings acts as a stiffening ring to enable Clamp-Together duct to withstand much higher pressures than spiral or standard rolled duct.
The lifetime-guaranteed Forever Clamp is made of stainless steel and fitted with a winged O-ring gasket made of N-butyl rubber that resists most chemicals and oils and is suitable for temperatures to 250°F. Other gasket materials include red silicon, Viton, and Gore-Tex®.
Adjustable sleeves and components make field fitting to any length possible. Nominal 5' lengths of duct have a rolled lip on each end, which can be cut down and slid into the sleeve or fitting and secured with an O-ring and Forever-Clamp. Various hanging systems are available, including K&B's K-wick cable system, which is 70% faster than using threaded rod, conduit or saddles.
K&B Duct can provide free 3-D design, working from simple hand sketches. A project inventory of all standard and special parts is then developed. At the customer's request and for no additional cost, components are boxed and marked with sections/segments packed together for efficient staging at the job site.
For additional information, contact Steve McDaniel at K&B Duct, toll-free/ 866-562-3828 or smcdaniel@kirkblum.com.
|
|
|
|
|
|
|
| 
