Clamp-On Wrench converts cap screws into large knobs.
September 6, 2006 -
Knurled, clamp-on Nut Buddy(TM) allows spin-on and spin-off adjustments, permitting rapid tool changes. Machined from aluminum with anodized finish, tool has round bore to fit socket cap screws from ¼-½ in. diameter. It is also available with hex bore for use on hex nuts and hose fittings. Wrench can be hand tightened.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Stafford Manufacturing Corp.
P.O. Box 2370
Woburn, MA, 01888
USA
Clamp-On Wrench Converts Cap Screws into Large Knobs
A new knurled, clamp-on wrench that fits over a socket cap screw to turn
it into a large knob that permits rapid tool changes is being introduced by Stafford Manufacturing Corp. of Wilmington, Massachusetts.
The Nut Buddy(TM) for socket cap screws is a knurled, clamp-on wrench that converts any socket cap screw into a large knob to allow spin on and spin off adjustments. Permitting rapid tool changes, this compact wrench can be hand tightened but still allows for conventional wrenches when high torquing is required.
Featuring an easy to grip, knurled outside surface, the Nut Buddy(TM) for socket cap screws is machined from aluminum, has a round bore to fit socket cap screws from 1/4" to 1/2" dia., and an anodized finish. It is also available with a hex bore for use with hex nuts and hose fittings.
The Nut Buddy(TM) for socket cap screws is priced from $15.84 (list). Literature is available upon request.
For more information contact:
Stafford Manufacturing Corporation
Jim Swiezynski, Technical Director
P.O. Box 277
North Reading MA 01864-0277
(800) 695-5551 FAX (978) 657-4731
e-mail: jswiezynski@staffordmfg.com
www.staffordmfg.com
|
|
|
|
|
|
|
| 
