Cable Tie Mounts tack onto metal surfaces.April 15, 2011 -
Designed for fast, clean way to fasten machinery wiring, Tack Mount cable tie mounts are manufactured from impact resistant plastic with pre-inserted hardened steel Metal-Tacks. Installed using air tool, units are permanently secured to metal surface, but permit rotation for final alignment of wiring. No drilling or tapping is required, nor any need to remove grease, oil and rust to prepare surfaces. Supporting up to 250 lb, they can fasten into steel, cast iron, and aluminum.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Gripnail Corp.
97 Dexter Rd.
East Providence, RI, 02914
USA
New Tack Mounts from Gripnail
A Faster, Cleaner Way to Fasten Machinery Wiring
New Tack Mounts from Gripnail make the installation of machinery wiring faster and easier by eliminating hours of preparatory work previously required to install cable tie mounting brackets. Tack Mounts fasten without creating drill chips that can damage valve seats and electric motors or contaminate equipment intended for use in clean environments.
Tack Mounts are manufactured from a special impact resistant plastic with pre-inserted hardened steel Metal-Tacks. Simply place the Tack-Mount on the tip of an Amtak air tool, position it and drive the pre-inserted Metal-Tack directly into the metal surface.
With Tack Mounts, no drilling or tapping is required. Nor is there any need to remove grease, oil and rust to prepare surfaces, as would be the case for adhesive-backed tie mounts.
Each Tack Mount will support up to 250 pounds and can fasten into steel, cast iron, and aluminum. Upon impact Tack-Mounts are permanently secured to the metal surface. However, they permit rotation for final alignment of the wiring.
In less than a minute see how fast and easy it is to fasten wire ties with Tack Mounts. Watch the movie at: http://www.gripnail.com/tackMounts.html
Gripnail Corporation is an employee owned ISO9001: 2008 registered, manufacturer of specialty fasteners and fastener application equipment headquartered in East Providence, Rhode Island. Since 1966 our ergonomically designed pneumatic hand tools and accessories have improved their users' safety, comfort and productivity.
|
|
|
|
|
|
|
| 
