Cable Pull Switch isolates power in case of shut-downs.
April 13, 2010 -
Supplied in die cast aluminum housing rated to IP67, Series CPS can isolate power to conveyor system or other similar process equipment in case of shut-down condition. Steel wire is placed along side of conveyor and attached to cable pull switch. When cable is pulled at any point along conveyor, it will trip cable pull switch and cause conveyor to shut down. Manual reset of CPS is required to restart conveyor, and universal design accommodates bi-directional activation.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Dwyer Instruments, Inc.
Hwy. 212 at 12
Michigan City, IN, 46361
USA
NEW! Series CPS Cable Pull Switch
Dwyer Instruments, Inc., the preferred source for your complete range of practical and affordable instrumentation, is announcing the release of its NEW SERIES CPS CABLE PULL SWITCH.
The Series CPS Cable Pull Switch is designed to provide a switching system to isolate the power to the conveyor system or other similar process equipment in event of a shut-down condition. A steel wire is placed along the side of the conveyor and attached to the cable pull switch. When the cable is pulled at any point along the conveyor it will trip the cable pull switch causing the conveyor to shut down. To restart the conveyor the CPS must be manually reset. The Series CPS has a universal design for bi-directional activation and utilizes a highly visible red flag to indicate the switch status. The compact design makes it ideal for easy installation. The Series CPS housing is rugged die cast aluminum with an IP67 rating.
Complete details are available on our website @ http://www.dwyer-inst.com/Products/Pr...
Dwyer Instruments, Inc.
P.O. Box 373
Michigan City, IN 46361
Phone: (800) 872-9141 or (219) 879-8000
Fax: (219) 872-9057
Internet address: http://www.dwyer-inst.com/
E-mail: lit@dwyer-inst.com
|
|
|
|
|
|
|
|
|
|
| 
