Boring Heads feature integral shank design.
October 23, 2006 -
Available for CAT40, BT40, HSK-A63, and Capto C6 size spindles, EW2-50XL Series provides shorter tool than modular shank/boring head combination. Heads can be used with existing center-mounted boring bars from .078-2.125 in. dia and side-mounted insert holders from 3.15-6.00 in. dia. Units deliver precision finish boring with adjustment dial displaying increments of .0002 in./dial division and Vernier markings to accurately adjust to .00005 in. on diameter.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
BIG Kaiser Precision Tooling, Inc.
2600 Huntington Blvd.
Hoffman Estates, IL, 60192
USA
Integral Shank Boring Heads Provide Increased Performance Through Compact Design
BIG Kaiser Precision Tooling Inc. introduces a new integral-shank design for the popular EW2-50XL precision boring head.
The new boring heads will be available for CAT40, BT40, HSK-A63 and Capto C6 size spindles and provide a shorter tool than the modular shank/boring head combination. In the case of the CAT40 taper, the tool is shorter by over 1.3". This translates into a lighter and more rigid tool that can operate at higher cutting speeds and feeds.
For use with existing center-mounted boring bars (Ø.078"-2.125") and side-mounted insert holders (Ø3.15"-6.00"), these heads can be used for precision finish boring with a large adjustment dial displaying increments of .0002"/dial division and Vernier markings to accurately adjust to .00005" on diameter.
Additional accessories for the EW2-50XL heads allow for counter-boring, back-boring, chamfering and even O.D. turning with stock-standard components.
|
|
|
|
|
|
|
| 
