Blown Film Surface Winder handles up to 60 in. dia rolls.
July 16, 2010 -
Available in widths from 44-134 in., AC-driven SLC (SLiding Carriage) Series employs pneumatic cylinders for controlling winding force and is capable of winding rolls on 3 or 6 in. cores. Finished roll unloading system is independent from winding transfer cycle sequence, while roll carts and shaft handling are available to add automation. Other features include horizontal flat bed design, touch screen controls for winder settings, and 2 center slitters for multiple lane production.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Davis-Standard, Killion Specialty Systems
1 Extrusion Dr.
Pawcatuck, CT, 06379
USA
New Blown Film Surface Winder for Large Roll Diameters
(Somerville, N.J.) - Davis-Standard, LLC has introduced a new series of surface winders for blown film processors to complement the successful PAC series. The new SLC (SLiding Carriage) Series employs pneumatics instead of hydraulics for controlling the winding force. Like the PAC series, the SLC Series is capable of wound roll diameters up to 60 inches (1,500mm). The winder is available in widths from 44 to 134 inches (1,118 to 3,400mm) and capable of winding rolls on 3-inch (75mm) or 6-inch (150mm) cores. This winder is the latest addition to the company's successful and broad range of surface and center winders.
This AC-driven winder offers several unique engineering features for improved performance. The weight of the roll is supported by bearings located close to the wound roll edge and supported on a horizontal linear rail for greater shaft performance. The winding force is controlled via pneumatic cylinders with control feedback and taper capabilities. The finished roll unloading system is independent from the winding transfer cycle sequence shortening and streamlining new roll changes. Roll carts and shaft handling are available to add automation to fit each plant's needs.
Other features include a horizontal flat bed design, high capacity shaft bearings, high-speed pneumatic traversing knife assembly, web tension control, touch screen controls for winder settings, and two center slitters for multiple lane production. Options include additional slitters, a center drive feature, gap winding, shaft accelerator, cord expander roll and shaft extractor/cart.
For more information, contact Rick Keller at kellerr@bc-egan.com.
|
|
|
|
|
|
|
| 
