Blackening Gel works on iron and steel substrate parts.
April 9, 2004 - Available in 1 and 5 gal containers and ready for application, PRESTO BLACK® GEL can be used on any size part in limited quantities. After cleaning part surface, user swabs on layer of product with synthetic paintbrush and allows Gel to work for 2–10 min. Gel adheres to metal surface and blackens uniformly without running off, even on vertical surfaces. Resultant protective black finish inhibits water-spotting and corrosion during drying.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Birchwood Casey
7900 Fuller Rd.
Eden Prairie, MN, 55344 2138
USA
New Room Temperature Presto Black® Gel For Iron And Steel Introduced -- Enhances Metal Coating Capabilities
Call 952-937-7931 For Free Brochure
Or Go To www.birchwoodcasey.com For Product Data
Eden Prairie, Minnesota: BIRCHWOOD CASEY announces introduction of its new PRESTO BLACK® GEL for iron and steel substrate parts. Designed for use on any size part in limited quantities, the new Gel solves the application challenges of liquid products while producing an attractive, high quality, durable black finish.
New PRESTO BLACK GEL simplifies the metal blackening operation. After cleaning the part surface in the normal manner to remove cutting oils, coolants, etc., the user simply swabs on a layer of PRESTO BLACK GEL with a synthetic paintbrush, then allows the Gel to work for two to ten minutes. The Gel adheres to the metal surface and blackens uniformly without running off – even on vertical surfaces. With most parts, no re-application of the Gel is necessary.
When the desired depth of black is achieved, the Gel is simply rinsed off in the normal manner, leaving behind an invisible protective finish that inhibits water-spotting and corrosion during drying. The resultant black finish is clean and tightly bonded to the metal substrate, and can be sealed with BIRCHWOOD CASEY DRI TOUCH® PLUS IRP3 non-tacky rust preventive for maximum service life.
Ideal for finishing prototype and short run metal fabricated parts, PRESTO BLACK GEL can be used for blackening sharpened cutting tools, for molds, dies, and on previously blackened parts that have been re-machined. The PRESTO BLACK GEL also works well on platens, machine tables and fixturing devices that require re-blackening as part of maintenance or overhaul. This re-blackening can be done without disassembly of components when necessary.
PRESTO BLACK GEL provides a new, more efficient finishing option to manufacturers using immersion or brush-on finishing processes. While immersion tank lines are most economical in production-scale operations and brush-on techniques prevail in shops dealing with large workpieces and small part quantities, the PRESTO BLACK GEL process provides both of these manufacturers with a faster, cleaner and more cost-effective alternative.
Large workpieces using liquid blackeners, for example, are challenging to work with due to difficulties of applying the liquid to a large surface uniformly. Another problem is minimizing the runs and drips during the finishing cycle and re-applying the liquid where needed to carry the blackening process to completion. Following blackening, these workpieces need careful rinsing and drying to avoid any tendency to waterspot or corrode. Each of these steps can reduce the level of operator control needed to achieve satisfactory results. By contrast, the new PRESTO BLACK GEL simplifies the process and eliminates most of these problems.
PRESTO BLACK GEL is available in 1 gallon and 5 gallon containers ready for easy application.
Interested in more information, call 952-937-7931 for FREE brochure.
See at www.birchwoodcasey.com. Email: info@birchwoodcasey.com
Or write to Birchwood Casey, 7900 Fuller Road, Eden Prairie, Minnesota 55344-9702. Fax: 952-937-7979.
|
|
|
|
|
|
|
| 
