Automated System inspects and sorts worm gear shafts.September 5, 2008 -
Automatic system inspects worm gear shafts for journal diameter as well as presence of chips wrapped around ends. Oriented end-to-end, parts feed from vibratory bowl feeder to gravity track. Hold and release mechanism allows one part at a time into inspection nest, where LED inspection system measures journal diameter. Upon completion, vision system inspects parts for chips wrapped around either end with aid of back lighting. Accept/reject part gating system separates parts.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
CDS Manufacturing
1133 Mt. Read Blvd.
Rochester, NY, 14606
USA
Automatic System Inspects Worm Gear Shafts
CDS Manufacturing completed an automatic system that inspects worm gear shafts for journal diameter and inspects for the presence of chips wrapped around both ends. Parts we fed from a vibratory bowl feeder to a gravity track with the parts oriented end to end with the short end leading. A hold and release mechanism allowed one part at a time into an inspection nest where an LED inspection system measured the journal diameter. Upon completion of the journal diameter inspection, a vision system, with the aid of back lighting, inspected the part for chips wrapped around either end of the part. A good / reject part gating system was provided to separate the parts. Parts found to have a journal diameter that did not fall within the specified limits were gated as rejects. Parts that passed the LED and vision inspection were gated as good parts and exited the system via the output chute provided.
|
|
|
|
|
|
|
| 
