Dewatering-Drying system removes oversize/undersize particles.
May 8, 2008 -
Model K30-2-SS 30 in. dia circular vibratory screener integrated with Model K40/48-1FBD-SS 40 in. dia circular fluid bed dryer remove off-size particles while dewatering and drying on-size material. System removes up to 50 gpm of water and dries up to 700 lb of on-size particles per hr. Screener is equipped with imbalanced-weight gyratory motor that vibrates screening chamber, which is suspended on springs. Circular fluid bed dryer requires only one air inlet and outlet.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
MILLBURN, NJ- A new dewatering-drying system consisting of a circular vibratory screener integrated with a circular fluid bed dryer removes oversize and undersize particles while dewatering and drying on-size material, according to Henry Alamzad, president, Kason Corporation, here.
The screener, a 30 in. (762 mm) diameter Vibroscreen model K30-2-SS, together with the 40 in. (1016 mm) diameter Kason model K40/48-1FBD-SS dryer, removes up to 50 gallons (189 liters) of water per minute, and dries up to 700 lbs (318 kg) of on-size particles per hour.
The screener is equipped with an imbalanced-weight gyratory motor that vibrates the screening chamber, which is suspended on springs. Oversize particles travel in controlled spiral pathways from the center of the upper screen to a spout at the screen's periphery where they are discharged for reprocessing. On-size dewatered pellets falling onto the lower screen travel in controlled spiral pathways to an extended spout at the screen's periphery that leads to the fluid bed dryer. Undersize fines and water pass through the lower screen onto an integral metal chute and through a third spout for reprocessing.
The circular fluid bed dryer is typically half the size and weight of a rectangular fluid bed dryer of equivalent capacity and allows consolidation of all primary system components. Inherent strength of the circular processor eliminates the need for heavy-gauge walls and cross braces otherwise required to withstand continuous vibration, allowing vibratory motors to be downsized.
The circular unit also requires only one air inlet and outlet and has fewer weld seams, reducing overall size and construction cost, especially when finished to 3-A, FDA, and BISSC sanitary standards. Cleaning time is cut by more than 50 percent due to the reduction in interior seams and accessibility afforded by a quick-disconnect housing.
The company also manufactures other types and sizes of circular vibratory screeners and fluid bed processors, as well as centrifugal screeners for scalping and dewatering applications.
For information contact
Kason Corporation,
67-71 East Willow St.,
Millburn, NJ 07041,
1-973-467-8140,
info@kason.com, www.kason.com Company Information: Name: Kason Corporation Address: 67-71 E. Willow St. City: Millburn State: NJ ZIP: 07041 Country: USA Phone: 973-467-8140 FAX: 973-258-9533 http://www.kason.com
News provided by ThomasNet News® (TNN). TNN is a comprehensive source
of new and timely product information in the industrial marketplace. TNN supplies new product
information to the web sites, e-marketplaces and print publications that serve the
industrial marketplace. For press release submissions please go to
http://news.thomasnet.com/submitpr.html.
BY ACCESSING, BROWSING AND/OR USING THIS WEB SITE AND/OR ANY WEB SITES PROVIDED BY
ProductNews.com, YOU AGREE TO BE BOUND BY THE TERMS OF USE
AGREEMENT.
del.icio.us
DIGG
Facebook
Reddit
StumbleUpon
Twitter
![[Get Copyright Permissions]](http://license.icopyright.net/images/icopy-w.gif){kind=small}
