USB 3.0-SATA Bridge IC is intended for PC peripherals.
August 3, 2009 -
Supporting 5 Gbps max data-transfer rate, MB86C30A incorporates USB and SATA communication control circuits, protocol control and command control circuits, as well as AES encryption/decryption engine in one 64-pin, 7 x 7 x 0.4 mm LQFP. Dual AES operation modes - Cipher Block Chaining (CBC) and XTS - are supported along with 3 key lengths: 128 bit, 192 bit, and 256 bit. Encryption/decryption processing take place at speeds to 300 MBps, leaving USB 3.0 unhindered.
Fujitsu Now Shipping USB 3.0-SATA Bridge IC for PC Peripherals Supporting SuperSpeed USB 3.0
MB86C30A incorporates USB and SATA signal communication control circuits, protocol and command control circuits with a high-speed encryption/decryption engine on a single device
SUNNYVALE, Calif., July 27 -- Fujitsu Microelectronics America, Inc. (FMA) is now shipping its first generation USB 3.0-Serial ATA (SATA) bridge IC, built with Fujitsu's own physical layer device (PHY). The new MB86C30A supports the ultra-fast 5Gbps maximum data-transfer rate of USB 3.0, and incorporates an encryption/decryption engine. Samples are being built using Fujitsu's 65-nanometer low-power process technology, and are available now.
Compared with USB 2.0 connections, the MB86C30A bridge IC provides an order of magnitude increase in data transfer rates from external storage devices such as hard disk drives to PCs. The new bridge IC incorporates on a single chip the USB communication control circuits, SATA communication control circuits, and protocol control and command control circuits. These circuits are required to construct an external USB storage device and to realize 5Gbps data transfer to a host PC. (For an example of a system using the MB86C30A, visit this URL: http://www.fujitsu.com/downloads/MICR....)
The MB86C30A IC also contains an embedded Advanced Encryption Standard (AES engine to protect confidential data from being stolen, unintentionally leaked or lost, and to protect data following the disposal of storage devices. Hardware encryption does not burden the CPU of the host PC, and provides optimal protection for data. The encryption/decryption engine enables data to be easily encrypted for secure storage in external devices such as hard disk drives without impairing the performance of USB 3.0.
"The new USB 3.0-SATA bridge IC provides customers with an innovative, reliable, optimized chip design in a small package. Pricing is competitive because we are using our own PHY and process technology," said Davy Yoshida, director of business development of the Embedded Platform Solutions business group of Fujitsu Microelectronics America. "We expect our chip to be embedded in devices to be released by the end of this year."
"Fujitsu has applied its extensive expertise in low-power CMOS technologies for high-speed interfaces including Fast Ethernet, Gigabit Ethernet, PCI-express, SATA and IEEE 1394. This IC is the first in the MB86C30 series, which was jointly developed with Fujitsu Laboratories Limited, utilizing their high-speed serial interface technologies, and Fujitsu LSI Solution Limited. Fujitsu Microelectronics plans to strengthen and expand its lineup of USB 3.0 standard products for storage devices."
Features Full USB 3.0 Performance with Encryption Capabilities
Today, PCs and audio-visual equipment handle an expanding volume of data from digital photos to audio and video files, requiring storage devices to have increased volumes and speeds. The USB 2.0 interface, which is used widely in external hard drives and memory sticks, has had a maximum data transfer rate of 480Mbps. To provide faster speeds for reading and writing high volumes of data the USB 3.0 specification was ratified in November 2008. USB 3.0 supplies as much as 10 times the data transfer rate of USB 2.0, along with improved protocol efficiency and power management techniques. The maximum transfer rate of 5Gbps of USB 3.0 allows 10 to 30 GBytes of video data to be copied to a 3.5-inch hard disk drive in one-third to one-fourth the time USB 2.0 needs.
The MB86C30A bridge IC supports two AES operation modes: Cipher Block Chaining (CBC), a mode for encrypting block data, and XTS, the XEX encryption mode with tweak and ciphertext stealing. Both modes are ideal for hard disks in terms of security, strength and speed of encryption/decryption. Three key lengths are supported - 128bit, 192bit and 256bit. High-speed encryption and decryption processing at a maximum of 300 MByte/sec. provides throughput without impairing the performance of USB 3.0.
Availability
Samples of the MB86C30A manufactured in 65nm CMOS process technology are available now in LQFP 64-pin 7mm x 7mm (0.4mm pitch) packages. Volume pricing is available upon request.
About Fujitsu Microelectronics America, Inc.
Fujitsu Microelectronics America, Inc. (FMA) leads the industry in innovation. FMA provides high-quality, reliable semiconductor products and services for the wireless, automotive, consumer, and other markets throughout North and South America. For product information, visit the company's web site at http://us.fujitsu.com/micro/usb/ or address e-mail to inquiry@fma.fujitsu.com.
All product names mentioned herein are trademarks or registered trademarks of their respective owners.
ARM7TDMI-S is a trademark of ARM Limited in the EU and other countries.
Other company or product names referenced herein are trademarks or registered trademarks of their respective owners. Information provided in this press release is accurate at time of issue and is subject to change without advance notice.
CONTACT: Emi Igarashi of Fujitsu Microelectronics America, Inc., +1-408-737-5647, eigarash@fma.fujitsu.com; or Dick Davies of IPRA, +1-415-652-7515, ipra@mindspring.com, for Fujitsu Microelectronics +America, Inc.
Contacts:
Public Relations:
IPRA
Dick Davies
USA
Phone: 415-652-7515 E-mail this person
General Information:
Emi Igarashi
USA
Phone: 408-737-5647 E-mail this person Company Information: Name: Fujitsu Microelectronics Inc. Address: 3545 N. 1st St. City: San Jose State: CA ZIP: 95134 1804 Country: USA Phone: 800-553-2000 FAX: 408-432-9044 http://www.fujitsumicro.com
News provided by ThomasNet News® (TNN). TNN is a comprehensive source
of new and timely product information in the industrial marketplace. TNN supplies new product
information to the web sites, e-marketplaces and print publications that serve the
industrial marketplace. For press release submissions please go to
http://news.thomasnet.com/submitpr.html.
BY ACCESSING, BROWSING AND/OR USING THIS WEB SITE AND/OR ANY WEB SITES PROVIDED BY
ProductNews.com, YOU AGREE TO BE BOUND BY THE TERMS OF USE
AGREEMENT.
del.icio.us
DIGG
Facebook
Reddit
StumbleUpon
Twitter
![[Get Copyright Permissions]](http://license.icopyright.net/images/icopy-w.gif){kind=small}
