Compression Limiters absorb load in plastic assemblies.
February 25, 2008 -
Series CL500 roll-formed, insert-moldable Compression Limiters is designed around standard clearances for 6 and 8 mm bolts, while series CL550 is designed with additional clearance around bolts to accommodate greater positional tolerances. Standard material is low carbon steel with trivalent, hexavalent-free zinc plate finish for corrosion protection. They are used to preserve threaded joint's integrity when fastening plastic-to-plastic or plastic-to-metal assemblies.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
SPIROL Announces New Addition to Compression Limiter Line
Danielson, CT - SPIROL is pleased to announce the introduction of a new, innovative product line. The Series CL500 and CL550 roll formed, insert moldable Compression Limiters are designed to replace expensive machined limiters.
Compression Limiters are used to preserve a threaded joint's integrity when fastening plastic-to-plastic assemblies, or plastic-to-metal assemblies. As a bolt is tightened to achieve the required friction between threads, the plastic is compressed. Without the Compression Limiter, plastic will creep, resulting in the loosening and eventual failure of the joint. The Compression Limiter absorbs the load generated when the bolt has been tightened to its recommended value. The plastic is isolated from excessive compressive loads and plastic creep is not a factor in ensuring that the joint remains intact throughout the life of the product.
The standard material for this new series is low carbon steel with a trivalent (hexavalent free) zinc plate finish for corrosion protection. The Series CL500 is designed around standard industry accepted clearances for 6MM and 8MM bolts. The Series CL550 is designed with additional clearance around the bolts to accommodate greater positional tolerances.
This is a new addition to existing SPIROLŪ Compression Limiter lines consisting of the Series CL200 and CL250 (split seam) and Series CL101 and CL111 (solid knurled) designs.
SPIROL engineers will review your application needs and work with your design team to recommend the best solution at the lowest installed cost. To access this service, visit the SPIROL web site at www.spirol.com and select Compression Limiters under the Optimal Application Engineering portal.
SPIROL INTERNATIONAL CORPORATION is a leading manufacturer of a diverse line of engineered components for fastening and joining, including coiled and slotted spring pins, solid pins, disc springs, alignment dowels and bushings, spacers, compression limiters, machined nuts, threaded inserts for plastics, shims, pin and insert installation equipment, and vibratory parts feeders.
Contacts:
Marketing:
Christie Jones Marketing Manager
USA
Phone: 860-774-8571ext 5436 Company Information: Name: Spirol International Corp. Address: 30 Rock Ave. City: Danielson State: CT ZIP: 06239 1434 Country: USA Phone: 860-774-8571 FAX: 860-774-0487 http://www.spirol.com
News provided by ThomasNet News® (TNN). TNN is a comprehensive source
of new and timely product information in the industrial marketplace. TNN supplies new product
information to the web sites, e-marketplaces and print publications that serve the
industrial marketplace. For press release submissions please go to
http://news.thomasnet.com/submitpr.html.
BY ACCESSING, BROWSING AND/OR USING THIS WEB SITE AND/OR ANY WEB SITES PROVIDED BY
ProductNews.com, YOU AGREE TO BE BOUND BY THE TERMS OF USE
AGREEMENT.
del.icio.us
DIGG
Facebook
Reddit
StumbleUpon
Twitter
![[Get Copyright Permissions]](http://license.icopyright.net/images/icopy-w.gif){kind=small}
