Portable Calibrator provides 4-20 mA current loop signal.
Press Release Summary:
Packaged in 4 x 2.5 x 4 in. housing with belt clip, Model 420 is designed for calibration/test of DPMs, PLCs, transmitters, sensors, or any other device requiring 4-20 mA current loop signal. Powered by 9 V battery, unit operates down to 6 V and can drive up to 300 ohm loads or sustain up to 7 V burden of load. It features dual full-scale range of 19.99 and 25.0 mA, 10-turn potentiometer, and 3½ digit display that will only turn on if loop is closed.
Original Press Release:
New Low Cost Portable 4-20mA Calibrator
This low cost, portable calibrator model 420 was designed for calibration/test of DPMs, PLCs, transmitters, sensors or any other device requiring a 4-20mA current loop signal. The 4x2.5x4" housing comes with a belt clip for ease of operation. Powered by a 9V transistor-type battery, this unit operates down to 6V and can drive up to 300 Ohm loads or sustain up to 7V burden of the load. The calibrator features a dual full scale range of 19.99 and 25.0mA, a 10-turn potentiometer for precise. The 420 3 ½ digit built-in display will only turn on if the "loop" is closed (connected) useful for troubleshooting loops. For more information visit www.otekcorp.com or contact Otto Fest, OTEK Corporation at 520-748-7900, Fax: 520-790-2808, or email: Support@otekcorp.com OTEK is headquartered in Tucson, Arizona and manufactures and designs dpms, counters, timers, controllers, transmitters, and intelligent instrumentation for the process control industries. OTEK has been an innovator in process control technology since 1974.
