Research Team builds first quantum cascade laser on silicon.

Press Release Summary:



Team of researchers from across the country, led by Alexander Spott, University of California, Santa Barbara, have built the first quantum cascade laser on silicon. Advance may have applications that span from chemical bond spectroscopy and gas sensing, to astronomy and free-space communications. Next step for team is to improve heat dissipation to optimize performance of these QCLs and to allow them to make continuous-wave QCLs on silicon.



Original Press Release:



Team Builds First Quantum Cascade Laser on Silicon



Eliminates the need for an external light source for mid-infrared silicon photonic devices or photonic circuits



WASHINGTON – A team of researchers from across the country, led by Alexander Spott, University of California, Santa Barbara, USA, have built the first quantum cascade laser on silicon. The advance may have applications that span from chemical bond spectroscopy and gas sensing, to astronomy and free-space communications.



Integrating lasers directly on silicon chips is challenging, but it is much more efficient and compact than coupling external laser light to the chips. The indirect bandgap of silicon makes it difficult to build a laser out of silicon, but diode lasers can be built with III-V materials such as InP or GaAs. By directly bonding an III-V layer on top of the silicon wafer and then using the III-V layers to generate gain for the laser, this same group has integrated a multiple quantum well laser on silicon that operates at 2 µm. Limitations in diode lasers prevent going to longer wavelengths where there are many more applications, so the group turned their attention to using quantum cascade lasers instead.



Building a quantum cascade laser on silicon was a challenging task made more difficult by the fact that silicon dioxide becomes heavily absorptive at longer wavelengths in the mid-infrared. “This meant that not only did we have to build a different type of laser on silicon, we had to build a different silicon waveguide too,” Spott explained. “We built a type of waveguide called a SONOI waveguide [silicon-on-nitride-on-insulator, which uses a layer of silicon nitride [SiN underneath the silicon waveguide, rather than just SiO2.”



The breakthrough could lead to several applications, Spott explained. “Traditionally, silicon photonic devices operate at near-infrared wavelengths, with applications in data transmission and telecommunications. However, there is emerging research interest in building these silicon photonic devices for longer mid-infrared wavelengths,  for a range of sensing and detection applications, such as chemical bond spectroscopy, gas sensing, astronomy, oceanographic sensing, thermal imaging, explosive detection, and free-space communications.



The next step for the team is to improve the heat dissipation to improve the performance of these QCLs and to allow them to make continuous-wave QCLs on silicon. “We generally hope to improve the design to get higher powers and efficiency,” Spott said. “This brings us closer to building fully integrated mid-infrared devices on a silicon chip, such as spectrometers or gas sensors. Silicon is inexpensive, the fabrication can be scaled up to significantly reduce the cost of individual chips, and many small devices can be built on the same silicon chip – for example multiple different types of sensors operating at different mid-infrared wavelengths.”



This work is done in collaboration with the U.S. Naval Research Laboratory and the University of Wisconsin, Madison.



About the Presentation:

The presentation "Quantum Cascade Laser on Silicon at 4.8 ìm," by Alexander Spott, Jon Peters, Michael Davenport, Eric Stanton, Charles Merritt, William Bewley, Igor Vurgaftman, Jerry Meyer, Jeremy Kirch, Luke Mawst, Dan Botez, John Bowers, will take place from 14:00 – 16:00, Thursday, 09 June 2016, San Jose Convention Center, San Jose, California, USA.



Media Registration: A media room for credentialed press and analysts will be located on-site. Media interested in attending the event should register on the CLEO website media center: Media Center.



About CLEO

With a distinguished history as the industry's leading event on laser science, the Conference on Lasers and Electro-Optics (CLEO) is the premier international forum for scientific and technical optics, uniting the fields of lasers and opto-electronics by bringing together all aspects of laser technology, from basic research to industry applications. CLEO: Expo showcases the latest products and applications from more than 300 participating companies, providing hands-on demonstrations of the latest market innovations and applications. The Expo also offers valuable on-floor programming, including Market Focus and the Technology Transfer programs.



Managed by The Optical Society (OSA) and sponsored by the American Physical Society's Laser Science Division, IEEE Photonics Society and OSA, CLEO provides the full range of critical developments in the field, showcasing the most significant milestones from laboratory to marketplace. With an unparalleled breadth and depth of coverage, CLEO connects all of the critical vertical markets in lasers and electro-optics. For more information, visit the event website at cleoconference.org.



Media Contact:

MediaRelations@osa.org

All Topics