Welding End Prep Tool Bevels & Squares Pipe in One-Step |
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Esco Tool
50 Park St., P.O. Box 530
Medfield, MA, 02052
USA
 
Press release date: February 9, 2010
An I.D. clamping end prep tool that sets up quickly for the construction and repair of piping systems in refineries, power plants, and petrochemical facilities is available from ESCO Tool of Holliston, Massachusetts.
Esco's Prepzilla MILLHOG® pipe milling end prep tool features I.D. clamping and uses one mandrel and eight sets of clamps to fit pipe from 1-1/2" I.D. to 8-5/8" O.D. Capable of beveling (any angle) and squaring the pipe ends in one operation, this tool requires no special operator training and cuts hard-to-machine materials such as stainless steel and P-91 without fluids.
Equipped with a direct drive 2 HP air motor, supported by dual opposed tapered roller bearings, Esco's Prepzilla MILLHOG® generates 1,500 ft.-lbs. of torque at the cutting blade which pulls a thick chip and transfers heat away from the cutting surface to prevent work hardening and help prolong blade life. An optional cross-feed attachment can sever the HAZ section.
Esco's Prepzilla MILLHOG® is priced at $8,995.00 and is available for rent in the continental U.S.A. for $80.00 per day with 24-hour delivery.
For more information contact:
ESCO Tool
A Unit of Esco Technologies, Inc.
Matthew Brennan,
Marketing Director
75 October Hill Rd.
Holliston, MA 01746
(800) 343-6926
FAX (508) 359-4145
e-mail: matt@escotool.com
www.escotool.com
|
|
|
|
|
|
