Portable Infrared Analyzers Provide On-Site Measurement of Oil and Grease Levels in Hydraulic Fracturing Water |
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Wilks Enterprise, Inc.
25 Van Zant St., Ste. 8F
East Norwalk, CT, 06855
USA
Press release date: February 20, 2012
East Norwalk, CT - The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well. Whether the water is going to be taken off-site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the water. Waiting for remote laboratory results to determine the oil level can take several days to a week. The InfraCal TOG/TPH Analyzers allow for oil in water testing at the well site in less than 10-15 minutes. The sampling requires a few simple steps that can be performed by non-technical personnel. The water is mixed with the extraction solvent, shaken, and then presented to the InfraCal Analyzer for measurement. The same InfraCal TOG/TPH Analyzer can be used for measuring total petroleum hydrocarbons (TPH) in soil if a spill or pond leak occurs to determine the contaminated area.
This type of measurement is not new as infrared measurement of oil and grease levels in produced water has been used in the petroleum industry on highly regulated off-shore and on-shore oil platforms for well over 30 years. The InfraCal TOG/TPH Analyzers are used worldwide for this particular type of measurement.
InfraCal TOG/TPH Analyzers offer a simple and quick measurement procedure that can help operators ensure the oil/water separator is working properly before it creates a sheen on an evaporation pond or before the water undergoes further treatment for reinjection. Operators can easily assess their system's efficiency and adjust parameters without waiting a week for an off-site laboratory result.
For further information on the InfraCal TOG/TPH Analyzers for on-site oil/grease measurements in hydraulic fracturing water, please contact: Wilks Enterprise, Inc., 25 Van Zant Street, Ste. 8F, E. Norwalk, CT 06855 TEL: 203-855-9136; FAX: 203-838-9868; Email: info@wilksir.com; or the information can be downloaded from the Wilks website: http://www.wilksir.com/pdf/Frac_Water_OG_Produced_Water.pdf
About Wilks Enterprise, Inc.
Headquartered in E. Norwalk, Connecticut, Wilks Enterprise specializes in easy-to-use, portable mid-infrared analyzers for specific measurement applications. All Wilks analyzers have been specifically designed for on-site use by non-technical personnel and are used for a wide variety of applications in the biofuels, environmental, petrochemical, quality control, and manufacturing industries. These portable analyzers enable analytical measurements to be made in the field, helping to eliminate the wait for off-site lab results.
For further press information or images, please contact Carol Tunick, VP - Marketing, at 203-855-9136 or email: ctunick@wilksir.com.
InfraCal and Wilks are trademarks of Wilks Enterprise, Inc.
|
|
|
|
|
|
