New FIPA Needle Grippers: Grip Textiles, Felts and Materials Delicately |
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
FIPA, Inc.
530 Means St., Suite 120
Atlanta, GA, 30318
USA
Press release date: September 1, 2010
FIPA relies on compatible components and solutions. The product range is modified constantly in direct consultation with customers - and supplemented, if necessary, to meet the requirements, and "in the case of the needle gripper, as a matter of fact, by six new models", reports the FIPA President and Owner Mr Rainer Mehrer.
The FIPA Needle Grippers at a glance
They provide a delicate and firm grip and high production rates along with low down times. In addition, each design has special strengths for various areas of application:
The needle gripper, NG, can adapt itself to different fabric thicknesses, while maintaining short cycle times, the NHA model has a flat piercing angle for gripping thin components. The NHK and NHP varieties have needles that can be replaced individually, and a center borehole for insertion into rails or positioning pins - the small design of the NHL model enables gripping of textiles from the border.
NHS needle grippers, in turn, can lift thick and heavy items using thick needles and a large needle stroke, whereas the NHT model is best suited to handle thin materials. Two needle plates that can be replaced independently are a characteristic feature of both types.
Sincerely Yours
Tom Herndon
General Manager
FIPA Inc.
102 Kingussie Ct
Cary, NC 27511
Phone: (800) 913-7002
Cell: (919) 244-1848
Fax: (919) 573-0871
mailto:therndon@fipa.com
mailto:sales.us@fipa.com
http://www.fipa.com
Warehouse
7750 The Bluffs,
Suite #104
Austell, GA 30168
Fax: (919) 573-0871
|
|
|
|
|
|
| 
