Products in the News

Barrus' New Generation 'Inversion Protected' Marine Engines Use Heason Supplied Linear Actuator in Novel Valve Design

Share Like Tweet Add Email

Heason Technology Ltd

Unit 6 Lawson Hunt Industrial Park, Horsham, United Kingdom

Original Press Release

Barrus' New Generation 'Inversion Protected' Marine Engines Use Heason Supplied Linear Actuator in Novel Valve Design

Press release date: June 1, 2014

• Standard IP65 linear actuator fulfils marine environment specification for valve positioning

Slinfold, UK — The Special Products Division of E.P Barrus Ltd, design and build customised marine engines for the RNLI, UK MoD and many global search and rescue organisations. Since the 1970s, Barrus has led the field in Post Immersion Restart System (PIRS) 2-stroke engines which have the ability to restart after complete submersion by rapidly evacuating water from the cylinder head, transfer ports and the fuel system. Following continuous product development in this demanding application area the Bicester based manufacturer has now introduced a new generation of environmentally friendly 4-stroke engines which actually prevent water entering through the inlet, vents and exhaust system using a patented valve arrangement which is actuated immediately a sensor network detects that immersion has taken place. This new 'Inversion Protected' technology not only cuts down restart time from typically 40 seconds to just 10 seconds – a major factor in a search and rescue situation - but also reduces internal engine damage or deterioration due to water ingress for much improved reliability and extended engine life.

As part of the specialised engine design, Barrus have selected Thomson Electrak 1 series linear actuators to drive the inversion protection valve following application support from motion control specialist Heason Technology. These IP65 rated linear actuators are mounted on the exposed engine completely fulfilling the Barrus specification, but nonetheless are supplied as a low-cost off-the-shelf standard solution. The Electrak1 features a simple 2-wire DC motor which is switched to actuate the valve following boat roll-over whilst a manual input is used to reset the system. The robust and durable sealed design includes an aluminium/zinc corrosion resistant housing and stainless steel actuating rod. Electrak 1 actuators are widely used and well proven across demanding applications in rigorous operating conditions and provide consistent, repeatable performance in extreme temperature and humidity conditions. The Electrak actuator was also chosen for its self-locking acme screw drive that will not allow the valve to back drive, and with the added benefit of a small and compact dimensions for convenient mounting within the space restricted marine engine. The clevis mount design makes installation and removal straightforward whilst the auto reset thermal switch motor protection and integral end-of-stroke limit switches ensure safe operation.

About Heason Technology
Heason Technology, part of the Variohm Holdings Group, works closely with its global distribution partners to provide a wide range of mechanical and electronics based motion control components and motion sub systems; and through its own customised design and engineering service is able to offer these as completely integrated positioning systems solutions based on a wide range of mechanical and control technologies.

For company and technical information, please contact Jon Howard:

Heason Technology Limited
Motion Solutions Centre
Spring Copse Business Park
Slinfold, West Sussex
RH13 0SZ, UK
Tel: + +44 (0) 1403 792 300
Email:  jhoward@heason.com
Web:  www.heason.com

Share Like Tweet Add Email

LIKE THIS ARTICLE? DON’T MISS OUT ON OTHERS! Get Thomasnet’s industry newsletter now

Comments

comments powered by Disqus