PIC Design
Middlebury, CT 06762
Ball Screws are typically 90% efficient.
Ball Screws run at speeds of over 2,000 ipm and operate with normal efficiency between -65 and 300Ã-
Read More »
Positioning Table offers ball or crossed roller elments.
Open frame table is designed for applications requiring backlighting. Ball or crossed roller elements handle loads of 225 or 450 lbs, respectively. Both versions provide smooth motion from precision rolled lead screw and have positional accuracy and repeatability within 0.0005 in. along total 6 in. range. Maximum screw speeds range from 300 to 800 rpm with acceleration of 12 in./secÃ-². Table...
Read More »Speed Reducers provide high torque in small size.
HHB Series has crossed helical gears and HWB Series uses worm and wheel gear. Both single reduction models are available with ratios from 1:1 to 60:1 and torque outputs up to 77 lb-in. All accommodate inch or metric bores via interchangeable shafting. Backlash is as low as 45 min. in some models. Input speeds as high as 6,000 rpm can be accommodated. Right angle input drive to output takeoffs are...
Read More »
Ball Screws are typically 90% efficient.
Ball Screws run at speeds of over 2,000 ipm and operate with normal efficiency between -65 and 300Ã-
Read More »
Positioning Table offers ball or crossed roller elments.
Open frame table is designed for applications requiring backlighting. Ball or crossed roller elements handle loads of 225 or 450 lbs, respectively. Both versions provide smooth motion from precision rolled lead screw and have positional accuracy and repeatability within 0.0005 in. along total 6 in. range. Maximum screw speeds range from 300 to 800 rpm with acceleration of 12 in./secÃ-². Table...
Read More »Speed Reducers provide high torque in small size.
HHB Series has crossed helical gears and HWB Series uses worm and wheel gear. Both single reduction models are available with ratios from 1:1 to 60:1 and torque outputs up to 77 lb-in. All accommodate inch or metric bores via interchangeable shafting. Backlash is as low as 45 min. in some models. Input speeds as high as 6,000 rpm can be accommodated. Right angle input drive to output takeoffs are...
Read More »