Company News

Analog Devices, Inc.

3 Technology Way, Norwood, MA, 02062, US

  • 781-461-3354

General Information:
Colleen Cronin
USA
Phone: 781-937-1622
E-mail this person

Share Like Tweet Add Email

Latest New Product News from
Analog Devices, Inc.

Computer Hardware & Peripherals

Audio Bus Transceiver is fully AEC-Q100 qualified.

October 29, 2014

Supplied in 32-lead LFCSP, AD2410 Automotive Audio Bus (A²B) transceiver promotes vehicle fuel efficiency by reducing weight of existing cable harnesses. Digital bus technology distributes high fidelity audio and control data, together with clock and power, over one UTP wire. Transceiver provides 50 Mbps of data bandwidth and support for up to 32 discrete upstream and downstream audio channels. Daisy chaining is supported, and system delay is fully deterministic at all slave nodes. Read More

Test & Measuring Instruments, Electronic Components & Devices

Ka-Band HPA and Block Upconverter serves SatComm applications.

October 29, 2014

Intended for use in single-carrier satellite communications, 5.72 x 4.51 x 1.63 in. HMC7053 block upconverter and 5.0 x 4.51 x 1.145 in. HMC7054 high-power amplifier (HPA) operate in 29–31 GHz frequency output range and feature -60 dBc SFDR performance. Ka-band block upconverter features 1–2 GHz dual input IF at 0 dBm typ and 20 dB conversion gain. Ka-band HPA achieves linear output power of 37 dBm, offers 42 dB small signal gain, and operates at 5 V while drawing 14 A. Read More

Test & Measuring Instruments, Electronic Components & Devices

Dual D/A Converters support emerging E-band frequencies.

October 23, 2014

Enabling support of E-band (71–76 GHz, 81–86 GHz) frequencies, 16-bit AD9136 and 11-bit AD9135 suit telecom system manufacturers requiring microwave frequencies in point-to-point wireless backhaul equipment. Max sample rate of 2.8 GSPS allows multicarrier generation up to Nyquist frequency. Supporting complex input data rates up to 2.12 GSPS per D/A converter using 8-lane, 10.6 Gbps JESD204B interface, products achieve better than -80 dBc SFDR and offer noise performance of -163 dBm/Hz. Read More

Electronic Components & Devices, Electrical Equipment & Systems

Digital Isolators target SPI communications applications.

July 3, 2014

Based on iCoupler® digital isolator technology, ADuM315x SPIsolator™ Series features low propagation delay and jitter in CLK, MO-SI, MI-SO, and SS channels to support SPI clock rates up to 40 MHz. Family has 3.75 kVrms isolation rating and also supports maximum sample rate for select ADI 12-, 16-, and 18-bit precision A/D converters. Housed in 20-lead SSOP package, isolators are suited for distributed control systems, PLCs, and sensor monitors. Read More

Electronic Components & Devices, Mechanical Power Transmission

Operational Amplifier drives heavy loads at high output.

June 25, 2014

Delivering over 1 A output current, 40 V Model ADA4870 provides wide bandwidth of 52 MHz and slew rate of 2,500 V/µs to facilitate high-voltage pulses necessary to drive piezoelectric transducer in high-intensity focused ultrasound for medical treatment and procedures. In small-cell base stations and compact military radios, op amp assists with drive of power amplifier’s low impedance bias control to track envelope of RF signal, only using as much power for PA as needed to pass signal. Read More

Electronic Components & Devices, Test & Measuring Instruments

Quad-Channel 16-Bit IF DAC has programmable interpolation rate.

June 6, 2014

Enabling wideband and multiband wireless applications, AD9144 comes in 12 x 12 mm, 88-lead LFCSP and draws 1.5 W. While 82 dBc SFDR and max sample rate of 2.8 GSPS permit multicarrier generation up to Nyquist frequency, -164 dBm/Hz noise spectral density enables building of higher dynamic range transmitters. SFDR and distortion levels provide synthesis of wideband signals from baseband to high intermediate frequencies. For 6 carrier GSM IMD, DAC operates at 77 dBc at 75 MHZ IF. Read More

Optics & Photonics

Isolated Sigma-Delta Modulator fosters precision measurement.

June 3, 2014

Able to achieve 81 dB min signal-to-noise and distortion ratio (SINAD) @ 78 KSPS over -40 to +125°C range, AD7403 promotes current and voltage measurement accuracy in DC/AC power conversion applications and subsequently improves performance of motor drives by reducing torque ripple on motor shaft. SINAD value also increases power transfer efficiency in DC/AC power inverter applications. Modulator employs iCoupler® digital isolation technology and offers 1.5 µV/°C typ offset drift. Read More

Test & Measuring Instruments

Dual-Channel 14-bit ADC fosters direct RF sampling.

May 21, 2014

Used in communications, instrumentation, and military/aerospace applications, AD9680 features -154 dBFs/Hz noise density and wideband RF DAQ technology. This 1.25 V,14-bit, 1 GSPS ADC is designed for sampling wide bandwidth analog signals up to 2 GHz. When converting 1 GHz input, converter achieves SFDR performance of 80 dBc and 61.5 dBFS SNR while consuming 1.65 W total power per channel. Features also include DSP blocks and configurable JESD204B interface. Read More

Other Company News from
Analog Devices, Inc.