Company News

American Control Electronics

14300 De La Tour Drive, South Beloit, IL, 61080, USA

  • 844-262-6875

Latest New Product News from
American Control Electronics

Controls & Controllers, Electronic Components & Devices

MGC Series SCR Control meets UL61800-5-1 standards.

April 20, 2017

Operating on 115 or 230 VAC 50/60 Hz single phase power source, MGC Series SCR Control is designed for 90 or 180 VDC PMDC motors. Rated to 11 A maximum current and 50°C maximum temperature, unit provides 0.5G and + 0.1G on under and over 50 Hz vibration respectively. Using new current-limiting algorithm to prevent overshoot and reduces demagnetization, product offers 1.37 SCR form factor at... Read More

Controls & Controllers, Electronic Components & Devices, Mechanical Power Transmission

Regenerative SCR Control supports OEM applications.

October 19, 2016

Intended for use with permanent magnet DC motors only, MGB Series features streamlined design with power in, power out, speed pot, direction switch, and stop/start switch. Microprocessor allows for custom programming where needed. Featuring 115/230 Vac input, 90/180 Vdc armature output, and 8 A armature current, series is engineered for OEM applications that require controlled deceleration,... Read More

Controls & Controllers, Mechanical Power Transmission

Low-Voltage Motor Control uses single phase AC line source.

August 29, 2016

Combining regen-capable switching power supply with low voltage drive, Model DCH403-10 controls low voltage motors without negative effects of current spikes or large BUS voltage associated with typical 115/230 Vac controls. Built-in circuitry diverts regenerative current to dump resistor, allowing for quick braking. Additional features include NO or NC contacts for alarm output, torque mode... Read More

Controls & Controllers

Variable Frequency Drives offer simplicity of DC drives.

August 8, 2016

In contrast to complex programming associated with standard VFDs, ACF700 Series enables quick setup without any programming. Open chassis units are equipped with user-adjustable trim pots to set Max/Min Speeds, Slip Comp, Boost, Torque Limit, Accel and Decel/Injection Braking parameters. Rated from 1/60 to 1 hp, drives have 115/230 V single phase input and can provide single or 3-phase outputs of... Read More

Controls & Controllers, Mechanical Power Transmission

MPU-Based Motor Controller extends device run time.

May 4, 2016

Suited for mobile equipment and linear actuators, DCR Series provides control of PMDC motors. Ability to maintain variable speed control while batteries discharge increases run time for battery-powered devices. Along with 12–48 Vdc input and 1/100–7.5 hp ranges, this 4-quadrant drive features microprocessor-based design that offers flexibility for customized OEM solutions with... Read More

Controls & Controllers, Electrical Equipment & Systems, Mechanical Power Transmission

Actuator Control features microprocessor-based design.

September 21, 2015

Combining AC to DC switching power supply with regenerative PWM drive, DCH Series is suited for applications requiring control of 12 or 24 Vdc motors when only 115 or 230 Vac power is available. With isolated front end, series is compatible with 0-5 or 0-10 Vdc analog signals from any PLC. True low voltage output allows control over low voltage motors without current spikes or large Bus voltage.... Read More

Other Company News from
American Control Electronics